Skip to main content
Okhare Paul — Portfolio©2026
000
Back

Case study · 11 / 12

Delivery Drone

The drone I designed, wired and flew for my BEng

Fig. 11 — Delivery Drone
About the project

My final-year project for a BEng in Electrical and Electronics Engineering: the design, construction and implementation of a delivery drone. I bought the parts, designed the circuit, built it and flew it.

Before I wrote software for a living, I built a machine that had to leave the ground. The brief I set myself was simple to say and hard to do: a drone that can carry a parcel and stay level while it does. I started on paper, with a power budget. Every gram a drone carries costs battery, and every extra cell of battery adds grams, so the motors, the battery and the payload had to be chosen together, not one at a time. Then came the parts: the frame, the motors and their speed controllers, the propellers, the battery, the flight controller with its inertial sensors, an Arduino board, and a gimbal. I designed the electrical circuit that ties them together and built the power distribution by hand. The Arduino took the jobs the flight controller does not do, and the gimbal held the load steady while the airframe tilted round it. Most of the project happened on the bench: testing each motor, checking each connection, calibrating the sensors, and finding out why it would not hover level. Then it flew. That project is why I still think like an electrical engineer: budget first, test on the bench, and trust nothing until it has been measured.

Main features

What it does

  1. 01Lifts off, hovers and flies
  2. 02Carries a payload and keeps it level on a gimbal
  3. 03Holds itself steady using a flight controller and inertial sensors
  4. 04Runs its own extra logic on an Arduino board
  5. 05Feeds every motor from one battery through a hand-built power circuit
Approach

How it was solved

  1. 01Worked out the power budget first, so the motors, battery and payload were sized against each other
  2. 02Chose every part against a tight weight limit, because each gram costs flight time
  3. 03Designed the electrical circuit from the battery to the motors, speed controllers, flight controller and Arduino
  4. 04Soldered and assembled the power distribution by hand
  5. 05Mounted a gimbal so the load stays level while the airframe tilts to move
  6. 06Bench-tested each motor and connection before the first flight
  7. 07Calibrated the sensors and tuned the controller until the drone hovered level
Results

It flew. Designed on paper, built by hand and tested on the bench until it left the ground with its load.

Technologies

Stack

Flight
Flight controllerInertial sensorsMotorsElectronic speed controllersPropellers
Electronics
ArduinoGimbalPower distributionBatteryHand-built circuit
Design and test
Circuit designPower budgetingBench testingSensor calibration

That is the work. Now meet the person who built it.

Next project · 12 / 12Mini Bank